氯碱企业快速熔断器运行状况调查报告

以2018年58家氯碱企业供电、整流技术与设备现状调查数据为依据,阐述了国内氯碱企业中快速熔断器的运行状况。调查数据中包括50家氯碱企业的快速熔断器的基本运行数据、投运时间及设备来源等。汇总了各企业在氯碱生产中使用快速熔断器时遇到的问题、发生的故障甚至酿成的生产事故及对氯碱生产造成的影响。并分析了事故发生的原因,提出了预防及解决措施,总结了事故处理经验,旨为氯碱生产提供参考依据。     

不同水分工夫红茶贮藏过程中主要内含成分及感官品质变化研究

目的研究不同水分工夫红茶贮藏品质变化规律,为工夫红茶贮藏的适宜水分条件提供理论参考。方法系统比较不同水分工夫红茶(国家标准范围内)在自然贮藏条件下其主要内含成分及感官品质的变化。结果 1年贮藏期内,初始水分含量越低,含水率增长速度越快,总体上,茶叶初始水分含量高低决定贮藏过程中水分的高低。在短期贮藏(≤6月)时含水量越高的红茶中茶多酚、水浸出物保留量越多;长期贮藏(6月)时水分较低的红茶中茶多酚、水浸出物保留量越多。咖啡碱、可溶性糖在短期贮藏(≤6月)中水分含量适中的红茶中下降速度越慢;长期贮藏(6月)含水量较高的保留量越高。氨基酸含量在含水量越低的红茶中越高。初始水分含量高的红茶L*、a*、b*值均稍高于水分低的红茶。结论从综合品质的变化来看,本实验中以处理3含水率为5.93%的处理最好,处理2含水率为4.1%次之,处理1含水率为2.33%最差。     

负压差对固体进料系统压力分布和气固两相流动规律的影响

A series of experiments on a solid feed system was performed to investigate the effects of negative pressure gradient on the gas-solid flow pattern and hydrodynamic characteristics. Based on the non-fluidized gas-solid two phase flow and particulate mechanics in the standpipe, a method for predicting the pressure of the air passing through the recycle chamber and the pressure drop through the loop seal slit in these systems is also presented. The predicted pressure profile along the negative pressure gradient from the proposed model exhibits a good agreement with the experimental data. The experimental data show that the gas flow in the standpipe is always upward in the negative pressure gradients, while the direction of gas cannot be changed by the drag force. The solid flow rate, the materiel bed height in the recycle chamber (Hf), the pressure drop across the slit (△Pg） decrease with an increasing negative pressure gradient. At a given negative pressure gradient, the superficial gas velocity through the recycle chamber of the loop seal does not affect the pressure drop in standpipe. It increases with an increasing negative pressure gradient.     

水电站大型竖井施工安全风险控制措施研究

竖井是大型水电工程中广泛采用的重要建筑物,但竖井的传统施工方法存在施工程序复杂、人工劳动强度大、施工效率不高等特点,同时还存在较大的安全风险。通过对杨房沟水电站大型竖井施工过程的研究,总结出精细化控制爆破、小溜渣井施工方式,同时也设计了一套用于运输的综合提升系统。采用上述创新方法不仅减少了繁琐的施工程序,降低了安全施工风险,而且大量采用机械化手段进一步提高了施工效率,确保了该工程竖井施工的安全风险可控。相关措施可为类似工程的竖井施工提供较好的借鉴作用。     

Design of energy‐efficient train speed profiles considering fixed‐block signaling system

In dense traffic railway networks, trains may often slow down or stop between stations owing to previous train delays. If preceding train trajectory can be predicted, energy‐efficient driving can be achieved by suppressing unnecessary speed changes. In this paper, we propose an algorithm to find energy‐efficient driving considering fixed‐block signaling (FBS) system by using dynamic programming (DP). DP is suitable for use because it can optimize the control inputs with discrete and state constraints. In this paper, we discuss energy‐efficient driving by considering a FBS system using some case studies of simulation. In the simulation, we examine a technique to drive an express train in an energy‐efficient way when the preceding local train is running toward the station with passing loops. The results show that the proposed method can derive complex speed profiles for energy‐efficient driving and the train can be operated with a maximum reduced energy consumption of 8.3%.     

焦炉前反馈热工控制系统运行实践

焦炉生产是典型的大惯性、非线性、时变快的复杂系统，以“火落温度”为基础的焦炉前反馈热工控制系统，通过立火道温度自动测量与人工测温相关性分析、粗煤气温度测量与火落判断、标准温度的优化等运行实践，达到了自动火落时间判断、标准温度指导、加热和燃烧优化、高低温炉号判别等目的，对于稳定炉温、降低回炉煤气消耗、提高焦炭质量以及推进焦化企业技术进步具有重要意义。     

A Voltage Control Method for a Distributed Line Feeder by means of Multiagent Approach

This paper proposes a method for the coordinated control of power factor by means of a multiagent approach. The proposed multiagent system consists of two types of agent: single feeder agent (F_AG) and bus agent (B_AG). In the proposed system, an F_AG plays as an important role, which decides the power factors of all distributed generators by executing the load flow calculations repeatedly. The voltage control strategies are implemented as the class definition of Java into the system. In order to verify the performance of the proposed method, it has been applied to a typical distribution model system. The simulation results show that the system is able to control very violent fluctuation of the demands and the photovoltaic (PV) generations.     

基于现场监测与数值模拟的浅层采空区稳定性分析

隐患采空区是目前影响露天开采矿山安全生产的主要危害源之一。随着台阶开采的不断剥离,露天开采境界内各台阶与地下空区群的隔离层厚度越来越薄,随时有可能发生采空区顶板坍塌事故。考虑到露天矿采空区地质赋存条件和围岩稳固性等特征,以弓长岭露天铁矿浅层采空区为工程背景,运用现场监测和数值模拟相结合的手段综合分析了浅层采空区的稳定性。将液体静力水准地表沉降监测系统的监测数据与FLAC数值模拟结果对比,调整蠕变参数使得数值模拟的蠕变速率与现场监测结果一致,而后据此进行未来结果的预测。最终根据地表沉降数据确定的蠕变参数取值为A=1.0×10^-12、m=1.75、n=0.35。研究表明:静力水准测点地表最大沉降位移为-9.8 mm,蠕变计算结果顶板最大垂直位移约20.4 mm,应力最大值约25 MPa,综合分析显示该采空区较稳定。上述研究提供了一种基于采空区现场监测数据的数值模拟蠕变分析方法,可为类似矿山采空区稳定性分析提供借鉴。     

Simulation Study on Hydrogen-Heating-Power Poly-Generation System based on Solar Driven Supercritical Water Biomass Gasification with Compressed Gas Products as an Energy Storage System

Supercritical water gasification driven by solar energy is a promising way for clean utilization of biomass with high moisture content, but direct discharge of liquid residual causes energy waste and decreases energy efficiency. To reduce energy waste, a poly-generation system for hydrogen-rich gas production coupling heat supply and power generation based on supercritical water gasification of biomass driven by concentrated solar energy was established in this paper, which also provided a novel energy storage method to overcome the shortcomings of solar discontinuity. Thermodynamic model of the system was proposed and life cycle assessment(LCA) of the system was conducted. Influence of different parameters(temperature of 600℃ to 800℃, outlet temperature of heat exchanger of 42℃ to 56℃, biomass slurry concentration of 5% to 6.5%) on the gasification performance, energy and exergy efficiency, energy distribution and global warming potential(GWP) was discussed. The results indicated that hydrogen yield increased as gasification temperature increased since free radical reaction was enhanced which gas production reaction was classified into. Molar fraction of hydrogen increased as gasification temperature increased and reached 65.6% at 750℃. Energy and exergy efficiency of the system reached 74.84% and 34.87% at 700℃ and 600℃ respectively and that of gas production was 18.15% at 650℃, which was the highest. Increasing reaction temperature and decreasing biomass slurry concentration were effective ways to decrease GWP. Optimal operating parameter was reaction temperature of 650℃, outlet temperature of heat exchanger of 50℃ and biomass concentration of 5%.     

某船用柴油机排气管路流-固耦合计算与保温效果研究

对某船用柴油机排气管路的流动与传热过程开展流-固耦合仿真分析。结果表明:受排气管路结构影响，管内流动方向和流速发生变化，局部区域产生明显的回流现象；排气管路外表面温度分布差异较大，平均温度高达534 ℃。为达到柴油机安全设计要求，在排气管路外壁敷设保温材料。分析结果表明:气凝胶纳米材料的保温效果优于硅酸铝纤维材料，在相同的运行条件和使用要求下，气凝胶纳米材料的敷设厚度更薄。